NOTE: This process applies to the following EdanUSA Patient Monitors: iM8, iM50, iM60, iM70, iM80, X8, X10, X12, iM3 Press Main Menu Next, Select Maintenance Then, Select Factory Maintain Enter Password: 998 (Default is 998 when the verification code is 0000, if needed call our service team for your specific factory maintain password) Select Password…
NOTE: This process applies to the following EdanUSA Patient Monitors: EdanUSA iM Series iM8, iM50, iM60, iM70, iM80 To turn on the CO2 module function (if purchased), you will need to follow this step by step procedure: Press Main Menu Next, Select Maintenance Then, Select Factory Maintain Enter Password: 998 (Default is 998, if needed…
Kidney Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of the Kidney using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
Urology Bladder Jets Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of Urology Bladder Jets using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
Thyroid Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of the Thyroid using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
Spleen and Kidney Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of the Spleen and Kidney using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
Liver Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of the Liver using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
Carotid Ultrasound Demo Scan (Edan/Acclarix AX Series) Demo ultrasound scan of the Carotid using the Acclarix AX Series (AX2, AX3, AX18, AX28) by a certified Sonographer.
This is how you prepare the holter for patient use. Enter all of the patient’s information. Disconnect the cable and connect the holter. A screen will pop up after you connect the holter. Press the “M” button. This is just to check your channels — Channels 1, 2, and 3 — to make sure everything…
How to install a plate on an M3 You will need a Phillips screwdriver, the M3 plate, and 3 additional screws. Remove the 3 screws from the bottom of the machine Align the plate Line up the 3 additional screws to where you removed the original screws from Screw them in.